Detailed analysis
General information
“Overall quality” is a quick reading of the tank’s general condition: the higher the score, the closer all measured parameters are to the recommended target values. It is not a “judgment” of the tank, but a guide for setting priorities: an average score may hide 1 or 2 really important parameters that should be corrected first.
The “By major categories” chart shows where the biggest gap lies: basic values (salinity, KH), major elements (Ca, Mg…), nutrients (NO3, PO4), trace elements (I, Fe, Mn…), and pollutants. The idea is simple: you immediately spot the category or categories pulling the score down, then go to the detailed table to see exactly which elements are in “Warning” or “Needs correction”.
Method tip: always start by stabilizing salinity and KH (these are the foundations), then adjust the major elements (Calcium / Magnesium), and only then the nutrients and trace elements. And above all: correct gradually. Several small, well-controlled adjustments are better than one big correction all at once.
Overall quality
By major categories
These synthetic indicators give you an overall view of your aquarium’s chemical balance, beyond the individual values. Rather than analyzing each element separately, they group several related parameters together to assess overall consistency.
The “Macro / Halogens Average” corresponds to a grouping of major and halogen elements (such as calcium, magnesium, potassium, iodine, bromine, etc.). These elements play a central role in coral growth, biological stability, and the overall proper functioning of the tank.
The “Organic Factors Average” groups together the parameters related to nutrients and organic compounds (nitrates, phosphates, organic carbon, etc.). It helps assess whether the organic load is balanced, too high (risk of algae, cyanobacteria), or too low (risk of deficiencies and starving corals).
Ratios are expressed as percentages, with a target set at 100%. A ratio close to 100% indicates that, overall, the elements in the group are aligned with their target values. A ratio below 100% suggests an average deficiency, while a ratio above it may indicate an overall excess.
These averages do not replace a detailed element-by-element analysis, but they are ideal for quickly detecting an overall drift and tracking your tank’s evolution over time. Use them as trend indicators: if an average remains far from 100% over time, it is recommended to examine the relevant elements in the detailed table.
Macro / Halogens Average
Organic Factors Average
This panel gives you an immediate view of the parameters that require special attention. It highlights only the values that are outside the target zone, so you can focus on what matters most.
A “Needs correction” status indicates a significant deviation that should be treated as a priority. A “Warning” status indicates a more moderate deviation to watch and adjust gradually.
Filters let you display only “Needs correction” parameters, only those in “Warning”, or the full set. The detailed table below updates automatically.
Each element is clickable: one click scrolls to its row in the table, giving you quick access to the value, the visual gauge and the actions.
The detailed table groups together all the chemical elements measured in your aquarium, classified by major families to make it easier to read. Each row corresponds to a specific element (calcium, magnesium, iodine, nitrate, etc.), with all the information needed to understand its current situation.
The “Measurement” column shows the value detected in the analysis. If the element is marked as ND (not detected), it means it is below the laboratory’s detection limit. Right next to it, the visual deviation gauge lets you interpret the value at a glance: target zone (green), warning zone or needs-correction zone depending on the gap from the target.
The “Status” column summarizes this information with a clear label (OK, Warning, Needs correction) to help you prioritize actions.
The “Action” button opens a correction recommendation tailored to your volume and the observed deviation, while the “Info” button gives a more scientific explanation of the element’s role in the aquarium.
Use this table as your main decision tool: start with the “Needs correction” rows, then handle the “Warning” ones, and leave the OK parameters under simple monitoring.
Basic parameters
| Element | Measurement | Visual deviation | Status | Actions |
|---|---|---|---|---|
| DKH Carbonate hardness |
8.94 dKH
Ideal value :
7.5
|
|
Warning | |
| PSU Salinity |
33.24 PSU
Ideal value :
35
|
|
Warning |
Base
DKH
Carbonate hardness
Warning
Measured
8.94 dKH
→
Target
7.5
dKH
PSU
Salinity
Warning
Measured
33.24 PSU
→
Target
35
PSU
Major elements
| Element | Measurement | Visual deviation | Status | Actions |
|---|---|---|---|---|
| B Boron |
4.25 mg/L
Ideal value :
4.65
|
|
OK | |
| Br Bromine |
76.99 mg/L
Ideal value :
68
|
|
Warning | |
| Ca Calcium |
420.7 mg/L
Ideal value :
420
|
|
OK | |
| Cl Chloride |
18822 mg/L
Ideal value :
19500
|
|
OK | |
| F Fluoride |
0.63 mg/L
Ideal value :
1.3
|
|
Needs correction | |
| Mg Magnesium |
1352 mg/L
Ideal value :
1350
|
|
OK | |
| K Potassium |
388.8 mg/L
Ideal value :
400
|
|
OK | |
| Na Sodium |
10173 mg/L
Ideal value :
10700
|
|
OK | |
| Sr Strontium |
9.09 mg/L
Ideal value :
8
|
|
Warning | |
| S Sulfur |
847 mg/L
Ideal value :
900
|
|
Warning |
Major
B
Boron
OK
Measured
4.25 mg/L
→
Target
4.65
mg/L
Br
Bromine
Warning
Measured
76.99 mg/L
→
Target
68
mg/L
Ca
Calcium
OK
Measured
420.7 mg/L
→
Target
420
mg/L
Cl
Chloride
OK
Measured
18822 mg/L
→
Target
19500
mg/L
F
Fluoride
Needs correction
Measured
0.63 mg/L
→
Target
1.3
mg/L
Mg
Magnesium
OK
Measured
1352 mg/L
→
Target
1350
mg/L
K
Potassium
OK
Measured
388.8 mg/L
→
Target
400
mg/L
Na
Sodium
OK
Measured
10173 mg/L
→
Target
10700
mg/L
Sr
Strontium
Warning
Measured
9.09 mg/L
→
Target
8
mg/L
S
Sulfur
Warning
Measured
847 mg/L
→
Target
900
mg/L
Nutrients
| Element | Measurement | Visual deviation | Status | Actions |
|---|---|---|---|---|
| NO3 Nitrate |
1.3 mg/L
Ideal value :
5.5
|
|
OK | |
| PO4 Phosphate |
0.06 mg/L
Ideal value :
0.06
|
|
OK | |
| P Phosphorus |
20730 µg/L
Ideal value :
33
|
|
Needs correction |
Nutrients
NO3
Nitrate
OK
Measured
1.3 mg/L
→
Target
5.5
mg/L
PO4
Phosphate
OK
Measured
0.06 mg/L
→
Target
0.06
mg/L
P
Phosphorus
Needs correction
Measured
20730 µg/L
→
Target
33
µg/L
Trace elements
| Element | Measurement | Visual deviation | Status | Actions |
|---|---|---|---|---|
| Ba Barium |
39950 µg/L
Ideal value :
12.5
|
|
Needs correction | |
| Cr Chromium |
1290 µg/L
Ideal value :
0.5
|
|
Needs correction | |
| Co Cobalt |
1950 µg/L
Ideal value :
0.25
|
|
Needs correction | |
| Cu Copper |
0 µg/L
Ideal value :
2
|
|
N/A | |
| I Iodine |
18000 µg/L
Ideal value :
67.5
|
|
Needs correction | |
| Fe Iron |
0 µg/L
Ideal value :
1.275
|
|
N/A | |
| Li Lithium |
143200 µg/L
Ideal value :
265
|
|
Needs correction | |
| Mn Manganese |
270 µg/L
Ideal value :
0.25
|
|
Needs correction | |
| Mo Molybdenum |
10840 µg/L
Ideal value :
15
|
|
Needs correction | |
| Ni Nickel |
19330 µg/L
Ideal value :
3
|
|
Needs correction | |
| Se Selenium |
0 µg/L
Ideal value :
0.5
|
|
N/A | |
| Si Silicon |
398400 µg/L
Ideal value :
150
|
|
Needs correction | |
| V Vanadium |
0 µg/L
Ideal value :
3
|
|
N/A | |
| Zn Zinc |
1240 µg/L
Ideal value :
5.5
|
|
Needs correction |
Minor
Ba
Barium
Needs correction
Measured
39950 µg/L
→
Target
12.5
µg/L
Cr
Chromium
Needs correction
Measured
1290 µg/L
→
Target
0.5
µg/L
Co
Cobalt
Needs correction
Measured
1950 µg/L
→
Target
0.25
µg/L
Cu
Copper
N/A
Measured
0 µg/L
→
Target
2
µg/L
I
Iodine
Needs correction
Measured
18000 µg/L
→
Target
67.5
µg/L
Fe
Iron
N/A
Measured
0 µg/L
→
Target
1.275
µg/L
Li
Lithium
Needs correction
Measured
143200 µg/L
→
Target
265
µg/L
Mn
Manganese
Needs correction
Measured
270 µg/L
→
Target
0.25
µg/L
Mo
Molybdenum
Needs correction
Measured
10840 µg/L
→
Target
15
µg/L
Ni
Nickel
Needs correction
Measured
19330 µg/L
→
Target
3
µg/L
Se
Selenium
N/A
Measured
0 µg/L
→
Target
0.5
µg/L
Si
Silicon
Needs correction
Measured
398400 µg/L
→
Target
150
µg/L
V
Vanadium
N/A
Measured
0 µg/L
→
Target
3
µg/L
Zn
Zinc
Needs correction
Measured
1240 µg/L
→
Target
5.5
µg/L
Pollutants
| Element | Measurement | Visual deviation | Status | Actions |
|---|---|---|---|---|
| Al Aluminum |
20.7 µg/L
Ideal value :
17.5
|
|
OK | |
| La Lanthanum |
0 µg/L
Ideal value :
2
|
|
N/A | |
| Sn Tin |
2420 µg/L
Ideal value :
5
|
|
Needs correction |